![]() ![]() ![]() IMPORTANT!!! Remove all grease on friction plate and disc with solvent.ġ8. Replace wheels, LIGHTLY grease shaft, if needed.ġ6. Rotate shaft as needed to check operation.ġ5. Insert and tighten bolts for shaft bearings. Reconnect shifter to friction disk assembly per your photo above. Insert drive shaft in place placing bearings with washers on the ends (held in place with low temp grease), CAREFULLY inserting the sprocket on drive shaft on driveshaft into drive chain. Clean excess oil, dirt, grease form inside of housing. Place new disk on drive shaft assembly.ġ2. Remove old disk from drive shaft assembly (3 bolts).ġ1. The washers for the shifter connection fall off, one for top one for bottom.ġ0. Take picture of gear assembly for reference, then remove drive shaft with friction when disc. Remove right side support (by moving clip and slide out.ĩ. Remove bolts of drive shaft bearings (1 on each side, 2 bolts per side).Ĩ. Put/ flip snow blower up on intake housing.ħ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |